Publicidad
Idiomas disponibles
Idiomas disponibles
Preparation
2
With the Plasma Display lying flat, insert and secure the
two installation bolts ➁ (M8 x 20 mm: black) in the holes
"a" located in center of the Plasma Display housing.
• At this point, tighten these bolts ➁ only until the threads
are no longer visible when viewed from the side (you will
be unable to attach the display if the bolts are screwed
in completely).
Installation
bolt ➁
Plasma Display
housing
Plasma Display
Sheet
• Make sure to remove the speaker mounting fittings.
NOTE
• When lying the Plasma Display down, be careful not to
scratch or damage it.
B
A
B ´
A ´
3
As shown in the above figure, hook the stand pipe holes
(pipe "B") onto the screw heads of the installation bolts ➁,
then slide the stand upwards to the main Plasma Display
until it engages the installation bolts ➁ (once put together
with the display, the stand will slide no more than 19 mm
(3/4 inch)).
Stop screwing
down the bolt
when the
threads are no
longer visible.
Installation bolts ➁
(M8 x 20 mm: black)
Holes "a"
(holes in center of
Plasma Display)
B
A
B ´
A ´
4
Pass the installation bolts ➀ (M8 x 40 mm: black) through
the stand pipes and tighten the installation bolts firmly
using the enclosed hexagonal wrench. (The holes should
be used in the proper combinations, "B" - "B").
5
Tighten the installation bolts ➁ firmly using the enclosed
hexagonal wrench.
Table top stand
6
Replace the Plasma Display to stand upright.
• For speaker installation, see "Installing the PIONEER
speaker" on page 20.
NOTE
• Insert the bolts in the holes vertically and do not tighten them
with more force than necessary.
• Place a sheet or protective cover to protect the display from
scratches or damage.
• Work only with the Plasma Display lying flat on a table or
similar surface.
• Move the stand so that the stand screw holes and the nuts
that connect the main display line up correctly.
Installation bolts ➀
(M8 x 40 mm: black)
(Step 4)
Slide the stand
(Step 3)
05
27
En
Publicidad
