Publicidad
Idiomas disponibles
Idiomas disponibles
Preparation
05
PDP-4272HD/PDP-4271HD/PDP-4270HD
CAUTION
The weight of a 42 inch Plasma Display is about 29 kg (64 lbs.),
it has no depth, and is unstable. Therefore, at least two people
must assemble and install it.
Detaching the stand
1
Loosen and remove the two installation bolts ➀ using the
enclosed hexagonal wrench.
Installation bolts ➀
(M8 x 30 mm: silver)
2
Loosen and remove the two installation bolts ➁ using the
enclosed hexagonal wrench.
Installation bolts ➁
(M8 x 60 mm: silver)
3
Remove the Plasma Display from the stand.
• Make sure to keep the installation bolts ➀ and ➁ that
have been removed as they are re-used when attaching
the stand to the Plasma Display.
NOTE
• Be sure to install it on a flat, stable location.
28
En
Attaching the stand again
1
Fit the stand's support columns to the bottom of the
Plasma Display as indicated by arrows, then slowly insert
them vertically.
• Be extremely careful not to insert the support columns
of the stand into any part of the Plasma Display other
than the stand insertion slots. Doing so might damage
the Plasma Display panel or its ports or result in the
warping of the stand.
Line up the column supports with
the bottom of the Plasma Display as
indicated in the accompanying diagram.
2
Attach the Plasma Display at the points indicated by the
arrows and tighten the installation bolts ➁ firmly using the
enclosed hexagonal wrench.
Installation bolts ➁
(M8 x 60 mm: silver)
3
Tighten the installation bolts ➀ firmly using the enclosed
hexagonal wrench.
Installation bolts ➀
(M8 x 30 mm: silver)
NOTE
• Be sure to install it on a flat, stable location.
• Insert the screws in the holes vertically and do not tighten
them with more force than necessary.
Publicidad
