Publicidad
Idiomas disponibles
Idiomas disponibles
TV Guide On Screen™ System Setup
07
Screen 8: Is a VCR Connected?
• If you select "Yes", you see Screen 9.
• If you select "No", you see Screen 14.
Screen 9: VCR Configuration Diagram
• This screen shows the correct way to install the G-LINK cable
from the back of the device to the recording device. Make
sure the G-LINK cable is properly installed.
• Press ENTER, and you see Screen 10.
Screen 10: VCR Brand Name
• Press
/
to select the brand of the recording device.
• Press ENTER, and you see Screen 11.
40
En
Screen 11: VCR Preparation
• Follow the on-screen instructions, and press ENTER to
display Screen 12.
Screen 12: VCR Code Testing
• When testing is done, Screen 13 displays automatically.
Screen 13: Did your VCR stop playing?
• If you select "Yes", you see Screen 14.
• If you select "No", a different code is tested in Screen 12.
NOTE
• Many VCRs require testing more than one code.
If you select "Test this code again", the same code is tested
again in Screen 12.
Publicidad
