De Dietrich DFP8363W Guia Del Usuario página 190

7
•
ANOMALIES AND SOLUTIONS
- «AS» is displayed (Auto Stop system).
This function stops heating the oven if you
forget to switch it off. Turn your oven to
STOP.
- Default code starting with «F». Your
oven has detected a problem.
Stop the oven for 30 minutes. If the fault
is still there, cut off the power supply for at
least one minute.
If the fault persists, contact the Customer
Service Department.
- The oven is not heating. Check that
the oven is correctly connected and that
your installation's fuse is not out of service.
Check that the oven is not set to «DEMO»
mode (see settings menu).
- The oven light is not working. Replace
the bulb or the fuse.
Check that the oven is correctly connected.
- The cooling fan continues to operate
after the oven stops. This is normal. It can
work for up to one hour after cooking to cool
down the oven. If it continues beyond this,
contact the Customer Service Department.
- The pyrolysis cleaning cycle does not
begin. Check that the door is locked. Call
the Customer Services Department if the
problem persists.
- The «door locking» symbol flashes in
the display. Door locking fault. Contact the
Customer Services Department.
- Vibration noise.
Check that the power cord is not coming
in contact with the rear wall. This has no
impact on the proper operation of your
device but can nevertheless generate a
vibration noise during ventilation. Remove
your device and move the cord. Replace
your oven.
29