Descargar Imprimir esta página

Dräger Oxy 3000 MK III Trainer Instrucciones De Uso página 15

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 32
3.1.2 Functional part
9
8
7
19
FOR TRAINING ONLY
7
Training heat exchanger
8
Mouthpiece
9
Neck strap (training)
10
Nose clip
11
Hose ring
12
O-ring (training)
13
Breathing hose
14
Starter (training)
15
Breathing bag
16
Cartridge (training)
17
Button loop
18
Goggles
19
Chest strap
3.2
Feature description
The training device consists of a casing with a simulated
functional part. In contrast to the oxygen self-rescuer, the
training device does not contain chemically bound oxygen.
The dimensions and weight of the training device approximate
those of the oxygen self-rescuer. The functional part
essentially corresponds to the structure of the oxygen self-
rescuer. The breathing bag of the training device does not fill
with oxygen. Instead, the training heat exchanger simulates
the respiratory resistance of the oxygen self-rescuer.
Instructions for use
|
Dräger Oxy 3000/6000 MK III Trainer
3.3
The training device is exclusively intended for training
10
purposes. It is used for practising how to open, don and
breathe with an oxygen self-rescuer from the Dräger
11
Oxy 3000 and Dräger Oxy 6000 series.
4
12
4.1
13
The support ring, carrying strap and casing protector are
14
not included in the scope of delivery of the training device.
These can, however, be additionally ordered and assembled
15
so that the training device corresponds to the oxygen self-
rescuer. Assembly information can be found in the
16
instructions for use for the oxygen self-rescuer.
17
4.2
Donning the device incorrectly may cause a delay when
18
using the oxygen self-rescuer in emergencies. The following
exercises will improve your donning of the oxygen self-
rescuer which could save your life.
Be sure to perform the following steps in the described
sequence.
1. Pull the opener up and press it into its end position. The
tightening straps then release automatically.
reused.
The sealing tag for the oxygen self-rescuer breaks to show
that the device was opened.
2. Remove the upper part of the casing.
Intended use
Use
Preparations before use
Donning procedure
The seal of the training device is elastic. It can be
|
Use
15

Publicidad

loading

Este manual también es adecuado para:

Oxy 6000 mk iii trainer