Publicidad
Idiomas disponibles
Idiomas disponibles
10. Single Phase Power Unit:
A) Attach (3) 5/16"-18NC x 1 ½" lg. flange head cap screws
to the adapter plate as shown with push nuts.
B) Attach the adapter plate to the column power unit
bracket with (3) 5/16"-18NC x ½" lg. flange head cap
screws as shown.
C) Attach the power unit to the adapter plate using the
existing 1 ½" lg. hardware and 5/16"-18NC flange head
nuts.
D) Add the last 5/16"-18NC x 1 ½" lg. flange head cap
screw and nut (upper left as shown) to complete the
power unit installation, Fig. 9.
E) Attach straight thread adapter, swivel elbow, flow
control regulator, and o-ring face seal tee as shown,
Fig. 10.
CAUTION
Over tightening locknut may tear O-ring or
distort threads in pump manifold outlet.
Single Phase Power Unit
(For DC Version see pages 14-23)
5/16"-18NC HEX FLGD
WZLOCK NUT
5/16"-18NC HEX FLGD
WZLOCK NUT
5/16"-18NC x 1/2" Lg. HEX FLGD
WZLOCK HHCS
(3) THREADED HOLES USED FOR
5/16" x 1/2" Lg. HEX FLGD WZLOCK HHCS
N567 ADAPTER PLATE
(ONLY USED ON SPO20)
5/16"-18NC x 1-1/2" Lg. HEX FLGD
WZLOCK HHCS
10
FOR SPO16
CAPACITY
16,000 LBS.
FOR SPO20
CAPACITY
20,000 LBS.
Fig. 9
Straight
Swivel
Flow Control
Adapter
Elbow
Regulator
Fig. 10
Tee
Publicidad
