Publicidad
Idiomas disponibles
Idiomas disponibles
To avoid personal injury and/or property damage, permit only trained personnel to op-
WARNING
erate lift. After reviewing these instructions, get familiar
with lift controls by running the lift through a few cycles before loading
vehicle on lift.
Always lift the vehicle using all four adapters. NEVER raise just one end, one
IMPORTANT
corner, or one side of vehicle.
SAFETY
CAUTION
INSTRUCTIONS
? ?
?
Lift to be used
Read operating
by trained operator
and safety manuals
only.
before using lift.
©
Observe and heed SAFETY, CAUTION, and WARNING labels
on the lift.
CAUTION
1. Lift must be fully lowered and
service bay clear of all personnel
before the vehicle is brought
on lift. Swing arms out to full
drive-thru position.
2. Spot vehicle over lift with left front
Use vehicle
wheel in proper spotting dish position,
manufacturer's
lift points.
see "positioning vehicle Fig 1.
©
3. Loading: Swing arms under vehicle and position
adapters at vehicle manufacturer's recommended
lift points, Fig. 2. Use optional adapter extensions
for under body clearance when required.
Note: Allow 2 seconds between motor
WARNING
starts. Failure to comply may cause
motor burnout.
4. To Raise Lift:
A. Push RAISE switch on power unit,
Fig. 3.
Remain clear of lift
when raising or
B. Stop before making contact with
lowering vehicle.
vehicle. Check arm restraint pins
©
for engagement. If required, slightly
move arm to allow restraint gear and
Remain clear of lift
when raising or
pawl to mesh. DO NOT hammer
lowering vehicle.
pin down as this will damage the
restraint gear teeth.
C. Raise vehicle until tires clear the
floor.
D. Stop and check adapters for secure
contact at vehicle manufacturer's
recommended lift points.
OPERATING INSTRUCTIONS
Surface Mounted Frame Engaging Lifts
CAUTION
Authorized personnel
Clear area if vehicle
only in lift area.
is in danger of falling.
©
©
4
E. Continue to raise to desired height
WARNING
only if vehicle is secure on lift.
F. DO NOT go under vehicle if all
four adapters are not in secure
contact at vehicle manufacturer's
recommended lift points.
G. Repeat complete spotting, loading
and raising procedures if required.
H. Lower lift onto locking latches.
©
DO NOT go under vehicle if locking
CAUTION
latches are not engaged.
Before attempting to lift pickup trucks or
WARNING
other truck frame vehicles, be sure that:
A.
Vehicle frame is strong enough
to support it's weight and has not
CAUTION
been weakened by modification
or corrosion.
B. Vehicle individual axle weight
does not exceed one-half lift
capacity.
Use height extenders
C. Adapters are in secure
when necessary
contact with frame at vehicle
to ensure
good contact.
©
manufacturers recommended lift
points.
CAUTION
D. Vehicle is stable on lift and
neither front nor "tail" heavy.
E. The overhead switch bar will contact
the highest point on the vehicle.
Auxiliary adapters
may reduce
load capacity.
©
•Adapter extensions are furnished in 5" & 10" in-
crements. The stack-up height should not exceed
15". Use adapter extension combination to keep
vehicle as level as possible while it is being sup-
ported by the lift.
*Maximum operation pressure is:
2538 psi for SPO15 Sprinter (31A0 Series)
2103 psi for SPO15 Sprinter (3A0 Series)
2500 psi for SPO16 Standard
2650 psi for SPO20 Standard
Publicidad
