Tripp-Lite PDU3EVN1G60B Manual Del Propietário página 27

Features
Network Interface
FUTURE USE
A1
STATUS
A2
RESET
A3
CONSOLE
ESC
Ethernet Port: Use this RJ45 jack to connect the PDU to the network
C
with a standard Ethernet patch cable. The behavior of the Activity LED
and Link LED
C2
with PoE (Power Over Ethernet) applications.
LED Function
Activity
Link
C
C2
C1
E
B
SERIAL
D
is shown in the table below. This port is not compatible
LED Color Off
Green No Activity
Yellow No Link
27
USB Ports: The two USB-A ports
A
and connect to one of four
A1 A2
different Tripp Lite EnviroSense2
(E2) environmental sensors*
for remote temperature or
temperature/humidity monitoring
(up to three E2 sensors can be
daisy-chained). The Micro-B USB
port is used for initial network
A3
interface configuration and direct
console access from a computer
running a terminal emulation
software..
*USB-A ports are designed for use with
E2 modules only. Do not connect other
USB devices to these ports.
Note: Only 2 of 3 USB ports can be
used simultaneously. For example:
2 USB-A (A1 and A2) or 1 USB-B
and the lower USB-A port (A3 and
A1); the upper USB-A port A2 cannot
connect with the USB-B port A3.
Serial: Serial connection is for
B
command line access from a
computer running a terminal
emulation software. The serial
connection uses a 3.5 mm serial
port and the included DB9 to 3.5
mm cable is needed to connect
to this PDU.
On
—
Link (Any Speed)
C1
Flashing
Activity
—