Tripp-Lite PDU3EVN1G60B Manual Del Propietário página 36

Troubleshooting
Event Log Message
Bootload Mode
Breaker 1 Open
Breaker 2 Open
Breaker 3 Open
Breaker 4 Open
Breaker 5 Open
Breaker 6 Open
Firmware Update
Line out of range
Notable Relay
Response Time
Outlet too near max
rating
Outlet turned off due
to overcurrent
System Startup
Thd out of range
Transfer to firmware
mismatch fault
Transfer to idle
Transfer to line
Transfer to line; partial
powerup
Transfer to reboot
Transfer to standby
Transfer to standby idle Unit transition to Standby Idle mode
Event Log and Descriptions
Message Occurs When...
It entered Bootload mode
Breaker 1 is open
Breaker 2 is open
Breaker 3 is open
Breaker 4 is open
Breaker 5 is open
Breaker 6 is open
The firmware has been updated
The line voltage is out of expected range
Relay timeout is set outside of allowed range
The load current applied to the outlet is causing
the outlet to approach its max rating
The ISO breaker turns off outlet due to
overcurrent
The unit is powering up and the system goes into
idle mode
THD is out of range
The firmware description from the Slave micro
does not match what's stored in the Master
micro
Unit transitioned to Idle mode
Unit transitioned to Line mode
Unit transitioned to Line Partial Powerup mode
Unit transitioned to Reboot mode
Unit transitioned to Standby mode
36