Tripp-Lite PDU3EVN1G60B Manual Del Propietário página 37

Troubleshooting
LCD Message Type
Circuit breaker Error Msg
open
Line voltage Error Msg
out of range
THD out of Error Msg
range
EEPROM Error Msg
operation
timeout
EEPROM Error Msg
queue overflow
EEPROM write Error Msg
fault
Factory restore Error Msg
data invalid
Fletcher Error Msg
Checksum
Error -- master
Fletcher Error Msg
Checksum
Error -- relay
Error and Fault Messages
Message
Occurs When...
Any circuit
breaker is open
Line VRMS out of
range
THD out of
setting range
When takes
longer than
expected to
access EEPROM
EEPROM Buffer
Size Remaining
is greater than
expected
EEPROM write
failure
Failure Read
NVR data from
the factory
restore section in
EEPROM
Main processor
Checksum Error
Secondary
processor
Checksum Error
37
How to Clear
Check the breaker and
load status. If you are
not able to identify the
issue, please contact
Customer Support.
Verify the Input Voltage
is within operating
range according to PDU
specifications. If you
are not able to identify
the issue, please
contact Customer
Support.
Clear the Error or Fault
Message via the LCD
interface. You may also
clear the message via
the PowerAlert network
management interface.
If it does not clear
the message, please
contact Customer
Support.