Tripp-Lite PDU3EVN1G60B Manual Del Propietário página 38

Troubleshooting
LCD Message Type
NVR status Error Msg
checksum
mismatch
Ramp/Shed Error Msg
Nvr Write
Failed
Relay in Error Msg
unexpected
state
Relay reset Error Msg
time out of
range
Relay set time Error Msg
out of range
Firmware Fault Msg
mismatch fault
Stack Overflow Fault Msg
Occurred
Supply monitor Fault Msg
interrupt
System tick Fault Msg
timeout
Error and Fault Messages
Message
Occurs When...
Code Checksum
Error for any
processor
Writing to
RampShed NVR
Failed
At least one relay
was measured
and found to be
in an unexpected
state
The Relay reset
time is outside
of the expected
range
The Relay set
time is outside
of the expected
range
The firmware
does not match
valid file
A stack overflow
condition occurs
The Power supply
is less than
Threshold
System Response
time out
38
How to Clear
Clear the Error or Fault
Message via the LCD
interface. You may also
clear the message via
the PowerAlert network
management interface.
If it does not clear
the message, please
contact Customer
Support.