Corghi EM9780 plus Manual De Uso página 64

machine by pressing the
If the
screen,
insert the USB key.
After pressing the button, the following image
is displayed on the screen while the file is be-
ing saved to the USB key.
The USB key can be removed from the machine
when the image disappears.
The file is saved to the USB key with a unique
file name, consisting of the total count of spins
performed by the machine (e.g. 000014) and,
if required, a custom file name entered by the
operator (customer name or vehicle license
plate number).
By pressing the network button
you can save the report of the measurements
made in .pdf format to a network directory.
FEEDBACK WINDOW
The feedback window, as shown in the figure
below, displays the following information:
- Name of operator (see the "Customisation"
section).
- Wheel dimensions during the last spin: white
if measured automatically; or yellow if set
manually.
- The status of the clamping brake (enabled or
not enabled)
- Enabling of the WM programme
- The selected balancing environment (ref. "Con-
figuration Programmes" section)
64 EM9780 plus - EM9780 C plus AutomaticLine - Operator's manual
button.
image appears on the
SHUTTING DOWN
This function starts the shutdown process which
protects the Windows operating system installed
on the mother board and depowers the machine.
Proceed as follows:
- Press the Enter button
- Wait for the PC to be turned off completely
as confirmed by an intermittent beep.
- Press the switch on the back of the body (C,
Fig. 5).
USING THE AUTOMATIC
WHEEL CLAMPING
SYSTEM C
NOTE:
After every power on, the first time the automatic
wheel clamping system is activated using the
pedal, the machine will perform a calibration by
automatically moving the two ratchets located on
the hub towards the outer side. When calibration
is complete, the operator can use the machine
as described below.
Wheel locking procedure with the automatic C:
Centring with cone at front
- Fit the wheel on the shaft, sliding it into place
until it rests against the flange.
- Fit the most suitable cone on the shaft and
insert it into the central hole of the wheel.
- Fit the locking device by making it slide on
the hub until it comes into contact with the
cone.
- Press the control pedal for at least one second.
Centring with cone at rear
- Fit the most suitable cone for the central hole
of the wheel on the shaft.
- Fit the wheel onto the cone, sliding it into
place until the cone comes into contact with
the plate that holds the spring.
.