Corghi EM9780 plus Manual De Uso página 65

- Apply the protective cap to the sleeve.
- Fit the locking device by making it slide on
the hub until it comes into contact with the
wheel.
- Press the control pedal for at least one second.
Wheel release
- Press the control pedal for at least one second
to release the wheel from the flange.
Centring with flanges
C hub removal
- Keep the Stop button
keypad pressed for at least 3 seconds to
lock the wheel-holder shaft and the internal
devices.
- Insert the C special key provided with the
machine in the C hub hole (Fig. 12).
- Unscrew the C hub completely.
- Mount the flange on the shaft and lock it with the
two screws (A, Fig. 13) using the CH 6 wrench.
A
- Lock the wheel onto the flange as usual.
EM9780 plus - EM9780 C plus AutomaticLine - Operator's manual
IMPORTANT
To work without the hub removed previously the
machine must be set in flange mode as described
in the "CONFIGURATION PROGRAMMES"
section.
C hub mounting
Proceed as follows to remount the C hub:
- Go to the utility and configuration programmes
and press the
wheel-holder shaft and the internal devices.
- Screw the C hub manually until it reaches the
on the
end position.
- Tighten the C hub by inserting the C special
wrench into the C hub hole (Fig. 14).
- To tighten the hub properly, a hammer stroke
must be used on the special C key (it is also
possible to use the caliper, hammer side, to
secure the spring weights).
12
The machine can be fitted with the WINUT
device - i.e. the activation of the automatic
wheel locking device C via the button on the
sleeve C (Fig.14a) rather than via the control
pedal (L, Fig.10).
13
icon to block the
WINUT DEVICE
14
UK
Fig. 14a
65