Corghi EM9780 plus Manual De Uso página 77

- use chalk to make a mark on the tyre at the 12
o'clock position, then press the
button on the monitor;
- Remove the wheel from the hub, then match the
mark on the tyre with the position of the valve.
Note: The operator can repeat the runout measure-
ment procedure at any time by selecting the Start
button .
Note: The operator can quit the procedure at any
time by selecting the Exit button
Note: The laser sensors may not measure rim
defectiveness correctly on particularly reflective
surfaces. In this case repeat the measurement
performing a new spin. If the problem persists abort
the measurement.
If a wheel is mounted, and geometric deformations
have been detected, you can view the maximum
deformation point in the following way:
- move the wheel manually in line with the vertical
bar or select the
In both cases, the machine automatically blocks the
wheel and the screen will show the animation
of the mounting of the wheel on the vehicle.
- make a chalk mark on the tyre at the 12 o'clock
position;
- remove the wheel from the hub, then mount the
wheel on the vehicle as shown in the animation
on the screen:
EM9780 plus - EM9780 C plus AutomaticLine - Operator's manual
or
.
Because of the play between the vehicle fixing
pins and the rim holes, this procedure reduces
any possible geometric deformation detected
on the wheel.
Note: The operator can repeat the run-out meas-
urement procedure at any time by selecting the
Start button
3.2. IPOS LITE
(INTELLIGENT POSITIONING PROGRAMME)
icon.
(available only if rear ultrasonic sensor is
present)
After checking the status of each wheel, the wheel
balancer uses this programme to automatically
suggest the optimal positioning of the wheel on
the vehicle, selecting one of the following criteria
indicated below:
-
-
To start the programme, proceed as follows:
1. Select the
screen. In the middle of the main balancing screen
.
radial run-out;
wheel unbalance.
icon on the main work
UK
77