Publicidad
Idiomas disponibles
Idiomas disponibles
status and/or the operating mode can be modified.
Each parameter can be modified using the arrow
keys
.
The parameters that can be modified are:
1. Language:
-
to set the preferred language
2. Timeout screensaver:
-
to set the waiting time before the main logo is
displayed
3. Radial runout threshold (1st harmonic):
-
to set the threshold that displays the measured
value in red
4. Radial runout threshold peak-to-peak:
-
to set the threshold that displays the measured
value in red
5. Lateral runout threshold (1st harmonic):
-
to set the threshold that displays the measured
value in red
6. Lateral runout threshold peak-to-peak:
-
to set the threshold that displays the measured
value in red
7. DIAGNOSIS CYCLE:
-
to activate the eventual diagnosis of the wheel:
OFF diagnostic cycle disabled
1 - FAST acquisition of radial eccentricity of the
complete wheel
2 - FULL radial eccentricity acquisition of the
complete wheel and rim
3 - PRO capturing radial eccentricity of the complete
wheel and rim in addition to the outboard side
rim of the rim.
The alarm indicator light is activated automati-
cally in the main working screen.
8. OPT warning:
-
to display the alarm indicator light in the main
working screen (YES enabled – NO disabled)
9. Disable laser:
-
to disable the lasers when faulty. If disabled,
the dimensions must be set manually and the
weights applied in the 12 o'clock position
10. Automatic position search (RPA):
-
to enable automatic position search at the end
of the spin (YES enabled – NO disabled)
EM9780 plus - EM9780 C plus AutomaticLine - Operator's manual
11. automatic light
-
to activate operation of the LED light as required
(YES activated – NO deactivated)
-
when the programme is active, the light is
enabled in the following cases:
-
during the entire measuring cycle, with the
exception of during dimension acquisition;
-
in CP (centred position) for an additional 30
seconds;
-
during the Hidden Weight programme when
selecting the two planes behind the spokes.
12. emergency opening/closure of system C
(wheel locking device)
DO NOT USE WITH MANUAL WHEEL
CLAMPING SYSTEM MODELS
-
to activate the emergency opening/closure
of system C on the basis of your needs (YES
enabled – NO disabled)
-
when the programme is enabled, you can still
open and close the device C even if the control
pedal C (L, Fig.10) or the WINUT device is not
working. Press
open or close the automatic locking device C.
13. weight adhesive weight
It is possible to select the width of the adhe-
sive weight used to balance the wheels from a
minimum of 15mm to a maximum of 40mm.
14 Cycle time
It is possible to change the launch cycle time:
-
STANDARD factory setting
-
FAST reduced cycle time of about 2 seconds
from the factory setting.
15. Automatic Hidden weight
-
to activate Hidden Program in Auto mode (YES
active - NO OFF)
If the program is disabled, you can run the
Hidden Mode in manual mode.
16. BEST FIT threshold:
- to set the threshold that allows the position to
be shown in the working environment and the
ROD environment.
17. BEST FIT working environment
- It is possible to enable the visualisation of the
position of the BEST FIT programme in the
working environment (YES activated – NO
deactivated) if the geometric deformation
on the work screen to
81
UK
Publicidad
