Corghi EM9780 plus Manual De Uso página 66

This device can also be fitted on other machines,
by requesting the relevant accessory.
On the work screen, the machine visualises certain
icons relating to the device:
- : indicates that the machine recog-
nises the WINUT device;
- : indicates that the battery in the sleeve
C is charged;
- : indicates that the battery in the sleeve C
is at roughly the halfway point of its charge level;
- :indicates that the battery in the sleeve C
needs to be replaced;
To replace the battery in the sleeve C, proceed
as follows:
- Open the sleeve C by loosening the six M3 fixing
screws (Fig.14b);
- Remove the card indside (Fig.14c);
66 EM9780 plus - EM9780 C plus AutomaticLine - Operator's manual
- Replace the battery in the sleeve C with a new
CR2450 3V;
- Assemble the sleeve C, following the disassembly
instructions in reverse order.
AUTOMATIC DIMENSION
Wheel spin takes place automatically by lowering
the guard or pressing the Start button
with the guard lowered.
During the spin, the balancer, using the front and
rear laser sensors, will process the rim dimensions
using a special software for the final unbalance
calculation.
At the end of the spin, the rated dimensions of
the wheel are displayed in the feedback window,
specifically:
- The nominal rim width (only for dyn, sta, alu3,
alu4 and alu5 programs).
- The nominal rim diameter.
- The distance from the body to the inner edge
of the rim.
Note: at the end of the spin, if the automatic posi-
tion search function is enabled, the wheel may spin
with the guard raised.
NOTE
If the width measurement is highlighted in
red, it means that one of the automatic control
parameters has not been met and it is therefore
advisable to check the dimension. Using the touch
14b
screen select, if necessary, the feedback window
and manually enter the nominal width of the rim,
press enter and exit the manual entry mode.
NOTE
If the laser sensors fail to operate, the geometric
data can be entered manually by following the
procedure indicated in the "Manual wheel data
entry" section. This function is present in the Utility
and Configuration programmes.
14c
NOTE
The laser sensors may not measure the rim dimen-
WHEEL SPIN AND
MEASUREMENT