Descargar Imprimir esta página

Corghi EM9780 plus Manual De Uso página 74

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

5.
AUTOMATIC CLAMPING SYSTEM HUB
REMOVAL/ASSEMBLY MODE
6.
CONFIGURATION PROGRAMMES
1. SPIN COUNTER
Three counters are displayed on the screen:
-
the number of partial spins made since the
last manual reset;
-
the total number of spins performed by the
machine since its first start-up;
-
the number of wheel spins performed since
the last sensitivity calibration.
If the Weight Management suite is enabled, the
spin counter icon in the Utility programmes menu
becomes
and displays:
-
the total number of spins performed by the
machine since its first start-up;
-
the number of partial spins made since the
last manual reset;
-
the total weight quantity saved by the machine
since its first start-up;
74
EM9780 plus - EM9780 C plus AutomaticLine - Operator's manual
-
the partial weight quantity saved since the
last manual reset;
-
two histograms that compare the quantity
of weight required if the "Less Weight" pro-
gramme
(red bar) is not used and
the quantity required if the "Less Weight"
programme
the entire service life of the machine for clip
and adhesive weights.
The Reset button
reset the partial spin counters and the weight
quantity saved.
To quit the counter display, press the Exit but-
ton
.
If connected to an approved printer, the Print
menu secondary control key
used to start the print procedure for the Less
Weight programme.
2. MANUAL ENTRY OF WHEEL DIMENSIONS
In the event of failure of the internal and/or
external laser sensors or incorrect measurement
of one of the three working dimensions, the
geometric data can be entered manually using
the following procedure.
A screen is displayed with the default or previ-
ously measured wheel dimensions.
Using the number pad, one or more of the wheel
dimensions can be changed.
-
The wheel balancer prepares for manual entry
of the distance.
-
Using the number pad, change the distance
displayed by entering the distance measured
with a tape measure between the right edge
of the body and the inner edge of the rim
(Fig. 20).
(green bar) is used for
can be used to
can be

Publicidad

loading

Este manual también es adecuado para:

Em9780 c plus automaticline