Publicidad
TROUBLESHOOTING
Incorrect operations are often mistaken for trouble and malfunctions. If you think that there is something wrong with this component,
check the points below. Sometimes the trouble may lie in another component. Investigate the other components and electrical
appliances being used.
If the trouble cannot be rectified even after exercising the checks listed below, ask your nearest PIONEER authorized service center or
your dealer to carry out repair work.
There is no power.
#AC cord is unplugged.
ePtug the power cord into a wall socket.
No sound from speakers.
e Volume is turned all the way down.
e Raise the volume setting.
e Speaker cords are connected with the vinyl | #Strip vinyl insulation from speaker wire tip
insulation stilt on.
before connecting.
e@Function is not set to the desired listening | eSelect the correct function.
source.
Sound from only one speaker.
eOne of the speaker cords is disconnected or | eConnect correctly or replace with a new
damaged.
cord.
No reception.
e Antenna is not connected.
e Connect the antenna correctly.
e Wrong radio band.
e Set to the desired radio band.
ie
somiea
eLoop antenna is not positioned properly.
e@ Change the loop antenna position.
elinterference from nearby fluorescent light, hair | eStop
using
the
device
causing
the
dryer or other electrical appliance.
interference.
Sound is distorted, or no stereo | e Antenna is in poor position.
sound (during FM broadcast).
e Broadcast is weak.
@ The MONO button is on.
e Change the antenna's position.
e Use an external antenna (page 8}.
ePress the MONO
button
(on the remote
control unit (page 20)).
|
tamer
|
Ganerat
e Load the disc correctly with the label side UP.
e Clean the disc.
When playback is started, it stops | eDisc is loaded upside down.
immediately.
e Dirt, etc. on the disc.
Pauses or stops during playback.
e Player is in pause mode.
e Press the Play/Pause (/Il) button (on the
remote control unit).
With certain discs, loud noise is | #Disc has a bad scratch or warp.
e@ Replace the disc.
produced, or play stops.
Cassette door does not open.
e@ Deck has not stopped.
@ Press the STOP (m) button.
e Power was switched off while a tape was | eSwitch on the power again.
running.
Cassette door does not close.
e Cassette Is inserted incorrectly.
e Reload the cassetie tape correctly.
Tape does not move.
Cannot record or copy tape.
e Erasure prevention tabs are broken off.
@Apply adhesive tape over the tab holes.
e@ Dirty head.
e Clean head (page 46).
Previously
recorded
sounds | eDirty head.
e Clean head (page 46}.
remained.
_
High-range
sounds
are over- | e The cassette tape used is a TYPE II (HIGH/CrOz)
| e Use only TYPE I (Normal) tapes.
emphasize.
or TYPE IV (Metal) tape.
CD Player
Cassette
Tape
Deck
=
| Remote control unit does not | e Batteries are dead or no batteries in the remote | elnsert new batteries.
>
control unit.
a
_
Oo
ePoor angle or too great a distance from the | Use within 7 meters and within a 30 degree
= SD
remote control sensor window.
angle of the remote sensor window (page 6).
os
eA fluorescent light is shining on the remote | «Turn off the light.
ae)
sensor window.
© od
3
;
=
Timer does not work.
e Current time is not set.
e Set current time.
2
e The TIMER button is set to the off position.
Set to the on position (page 42).
Abnormal functioning of this unit may be caused by static electricity or other external interference. To restore normal operation, turn
the power off and then on again or unplug the AC power cord and then plug it in again.
48
<XRE3003>
En
Publicidad
