Corghi ET88 Manual De Uso página 102

WARNING
The manufacturer declines all liability for claims deriving from the use on non-
original spares or accessories.
WARNING
Before carrying out any adjustments or performing maintenance operations,
disconnect the electrical power supply from the machine and make sure that all
moving parts are suitably immobilized.
WARNING
Do not remove or modify any parts of the machine except in the event of service
interventions.
ATTENTION
Keep the work area clean.
Do not clean the machine with compressed air or jets of water.
When cleaning the area take steps to avoid raising dust as far as possible.
- Keep the balancing machine shaft, the clamping ring-nut, the cones and the
centring flanges clean. Clean using a brush dipped in environmentally friendly
solvents.
- Handle cones and flanges with care to avoid the risk of dropping them and
causing damage that would affect centring precision.
- When not in use, store cones and flanges in a place where they are protected
from dust and dirt.
- Use ethyl alcohol to clean the level window.
- Calibrate the machine at least once every six months.
If the machine is to be scrapped, remove all electrical, electronic, and plastic
components and dispose of them separately, as provided for by local legislation.
102
MAINTENANCE
SCRAPPING
ET 88 operator's manual