Corghi ET88 Manual De Uso página 76

The other icons, which can be described inside the individual programs, will be
described directly in the respective operating phases.
BALANCING TRUCK OR CAR WHEELS
The ET88 balancing machine is able to balance both truck and car wheels.
Since there are substantial differences between the two balancing modes, the
appropriate balancing environment has to be selected in advance as described
below in the UTILITY PROGRAMS section. However, during the wheel spin the
machine is able to detect whether the wheel fitted on the shaft is in the truck or
car category; if the wheel category found is not the same as the function currently
selected, a warning message will appear on the screen.
The machine envisages automatic input of the distance value and input of the
width and diameter by means of the keypad.
- Bring the automatic sensor arm (A, fig. 4) into contact with the inside of the rim as
shown in fig. 14. The image relating to the geometrical dimensions of the wheel
appears on the screen. Take the greatest care to position the arm correctly in
order to obtain precise reading of the data.
- Keep the arm in contact with the rim until the machine has acquired and
displayed the wheel distance value.
76
Set automatic position search: opens the submenu with the
icons which allow activation or deactivation of the function for
automatic wheel position search at the end of the wheel spin.
Imbalance unit of measurement setting: activates the icons for
selecting the unit of measurement and the rounding with which
the imbalance values are to be displayed (grams / ounces).
Language setting: activates the icons for entering the language
in which the operating messages are required to appear.
Company data setting: activates the procedure for setting the
data (name, address, etc.) which will be displayed in the screen-
saver logo.
Help: recalls the information linked to the current video page to
the screen. If an error message is present, the first information
recalled relates to the types of error which may occur.
The instructions recalled with this icon are an addition to (and
not a replacement of) this operator manual to all intents.
WHEEL DATA INPUT
ET 88 operator's manual