Publicidad
Attaching
the presser
foot holder
m Attention:
Turn power switch to "0" before carrying out any of the
operations below.
Raise the needle to its highest position and raise the
presser foot lever. Attach the presser foot holder (b) to
the presser foot bar (a). (1)
e
'_
Attaching
the presser foot:
Lower the presser foot holder (b) until the cut-out (c) is
directly above the pin (d). (2)
Lower the presser foot holder (b) and the presser foot (f)
wilt engage automatically.
Removing
the presser foot:
Raise the presser foot.
Release the pressure foot by raising lever (e) located at
the back of the foot holder. (3)
Attaching
the seam guide:
Attach the seam guide (g) in the slot as illustrated. Adjust
the distance as required for hems, pleats, etc.... (4)
16
Publicidad
