Publicidad
Changing
the needle
(System
130/705H)
t_ Caution:
Turn power
switch
to
"0"
before
inserting or removing the need/e.
Replace the needle at the first sign of
thread breakage
or skipped
stitches.
Select the correct
type and size of
needle for the fabric to be sewn. Turn
the balance wheel towards you until
the
needle
is at highest
position.
Loosen the needle clamp
screw (A)
and tighten again after inserting the
new needle. (1)
The flat side
of the
needle
shaft
should be facing away from you (B).
Push
the
needle
up (C)
into the
needle clamp as far as it wilt go (D).
Tighten the needle clamp screw firmly.
The sewing
needle must always
be
straight and sharp for smooth sewing.
Replace the needle (2) if it is bent (A),
blunt (B) or the point is damaged (C).
22
Publicidad
