Fronius Robacta Drive CMT G Manual De Instrucciones página 35

WARNING!
Danger due to hot system components and/or equipment.
Can result in serious burns or scalding.
▶
Before starting work, allow all hot system components and/or equipment to
cool to +25°C/+77°F (e.g., coolant, water-cooled system components, wire-
feeder drive motor, etc.)
▶
Wear suitable protective equipment (e.g., heat-resistant gloves, safety gog-
gles, etc.) if cooling down is not possible.
WARNING!
Danger from contact with toxic welding fumes.
This can result in serious personal injuries.
▶
Always extract welding fumes.
▶
Ensure an adequate supply of fresh air. Ensure that there is a ventilation rate
of at least 20 m³ (169070.1 US gi) per hour at all times.
▶
If in doubt, a safety engineer should be commissioned to check the pollution
level in the workplace.
CAUTION!
Danger of burns from hot surface.
Serious personal injuries may result.
▶
When the ambient temperature in operation is at its maximum of 40°C, the
surface temperature of the Robacta Drive CMT G can rise as high as 90°C.
This is a normal operating temperature and does not endanger the Robacta
Drive CMT G.
35