LUND 67480 Manual Original página 10

EN
It is forbidden to drill any holes in the product, as well as make any other modifi cations of the
device not described in the manual.
Move the device only when cooled, grasping the housing. Do not move the device by pulling
on the power cord.
The temperature at the place of installation and use of the device must be within the range of
+10 C ÷ +38 C, and the relative humidity must be below 90% without condensation.
O O
Recommendations for connecting the device to the power supply
Before connecting the device to the power supply, make sure that the voltage, frequency, and
performance of the supply network correspond to the values shown on the device's rating
plate. The plug must fi t into the socket. It is forbidden to modify the plug in any way.
The device must be connected directly to a single power supply socket. It is forbidden to use
extension cords, adapters, or double sockets. The power supply circuit must be fi tted with a
protective conductor and at least a 16 A protective device.
Avoid contact of the power cord with sharp edges, hot objects or surfaces. During operation,
the power cord must always be fully extended, and the position of the power cord must be
set so that it does not become an obstacle during operation. The power cord should not be
placed in a manner that would pose a risk of tripping. The supply socket should be located in
a place where it is always possible to remove the device power cord plug quickly. Always pull
the power cord by the plug housing when unplugging it, never by the cord.
If the power cord or the plug is damaged, immediately disconnect it from the supply network
and contact an authorised service centre of the manufacturer for replacement. Do not use
the device with a damaged power cord or plug. The power cord or plug cannot be repaired
and must be replaced with a new one that is free of defects if these components are dam-
aged. Replacement of the power cord and plug must be carried out by an authorised service
centre of the manufacturer.
Instructions for the device's use
WARNING! The oven interior heats to a high temperature. Special care should be taken
when opening the heated oven. Steam can be released fi ercely. Never touch the oven in-
terior without ensuring that the oven and baking accessories have been completely cooled
down.
All activities requiring touching the heated device should be carried out while wearing kitchen
gloves protecting against high temperatures.
When preparing dishes that may spread hot food fragments, personal protective equipment
should be worn to protect from burns.
Make sure that the fl oor near the device is not slippery. This will prevent slipping, which can
cause serious injuries.
Observe the food at all times and prevent it from burning during its preparation. Food left
unattended can burn, which can cause fi re and serious burns.
Do not use a knife to cut food placed on the stone or in the baking form. This will damage their
surfaces and may aff ect food preparation.
When preparing dishes, touch the stone or the baking form surface only with utensils made
O R I G I N A L I N S T R U C T I O N S
10