BH FITNESS R309U Manual página 10

calories, go through the following
procedure: Once the user program
has been defined and before pressing
the START/STOP key, press and hold
the ENTER key for 4 seconds until the
time function starts to flash. Press the
UP▲/DOWN▼ keys to select the
time. Press the
program the distance. Press ENTER
again to program the calories. Press
START/STOP to start the exercise.
RANDOM FUNCTION.-
Use the UP▲/DOWN▼ keys to select
the RANDOM function and press
ENTER.
You will see a random program profile.
Press START/STOP
exercise. The duration of the program
graph is 16 minutes, divided into sixteen
minute stages.
To program time, distance and/or
calories, go through the following
procedure: Once the program has
been selected and before pressing the
START/STOP key, press the ENTER
key to program the time using the
UP▲/DOWN▼ keys. In this case the
time will be divided into sixteen
stages. Press the ENTER key to
program the distance. Press ENTER
again to program the calories. Press
START/STOP to start the exercise.
You can vary the exertion level during
the exercise
UP▲/DOWN▼ keys.
TELEMETRIC PULSE RATE.-
The monitor is equipped to receive
signals from
measurement system.
The system comprises of a receiver
(D) and a transmitter (chest band not
included) Fig.5.
(See telemetric pulse rate instruction
ENTER key
to start
by pressing
a telemetric
book).
HEART RATE CONTROL
PROGRAMS.-
Use the UP▲/DOWN▼ keys to select
the H.R.C function and press ENTER.
Use the UP▲/DOWN▼ keys to select
to
the desired option (55%, 75% 90% or
Tag) and press the ENTER key. The
first three represent the percentage with
respect to maximum heart rate (220-
age) and the fourth is used to specify
the target heart rate manually. If you
choose Tag then you should use the
UP▲/DOWN▼ keys to select the
desired heart rate and then press
ENTER. Press START/STOP to start
the
the exercise. The exertion level will
adjust automatically in accordance with
the selected hart rate value. If the pulse
rate is below the target value then the
exertion setting will increase by one
level every 30 seconds until it reaches
the maximum 16.
If the pulse rate is above the target
value the monitor will give out warning
beeps and reduce the exertion settings
by one level every 15 seconds until it
reaches the minimum 1. If the pulse rate
still stays above the target value for
more than 30 seconds the monitor will
beep and stop in order to protect the
user.
the
To program time, distance, and/or
calories, go through
procedure: Once the heart rate program
has been selected and before pressing
the START/STOP
pulse
ENTER key to program the time limit
using the UP▲/DOWN▼ keys. Press
ENTER again to program the distance.
Press the ENTER key one last time to
10
the following
key, press the