Olimpia splendid Bi2 WALL TR 1000 Manual De Instalación Y Mantenimiento página 49

To connect the presence sensor, it is necessary to use a double-insulated cable with a minimum section
of 2x0,5 mm and maximum length of 20 m. Keep this connection separated from the power supply line
2
of the appliance.
5.1.b - Terminal box positioning
Screw the terminal box (12) to the bracket (20) using the screws (20a) (fig.15).
a.
b. Slightly rotate the bracket (20) complete of terminal box (12) and place them on the side of the ap-
pliance in correspondence of the assembly holes.
Screw the bracket (20) to the appliance using the screws (20b) (fig.15).
c.
d. Connect the ground cable to the appliance structure using the supplied screw (Z) and the washer
(Y) (minimum force for screwing is 4 N) (fig.14).
Remount the cover (12b) of the box (12) and tighten the screws (12a) (fig.16).
e.
f. Remount the sides of the appliance as described in the previous paragraph.
Once the operations are complete, reposition the front panel taking care to connect the display connector.
Secure the front panel by means of the screws, then power the machine.
• When the unit is configured for remote control, the remote controller is disabled.
• It is not possible to control the flap from remote control.
• In this mode, the air probe installed on board the fan coil is ignored.
5.2 - BOARD CONFIGURATION
Work as follows:
a. Connect power supply, then ensure that the latter is set to any mode except for stand-by.
b. On the control panel, simultaneously press the key "
until an acoustic signal is emitted.
c. The display shows the reference to the parameter
d. Scroll using the key "
e. Press the key "
CF -> ...
f. Press key " " (T2) to access the value
g. Release and press key "
h. Press key " " or "
i. Press key " " (T3) to confirm the value
j. Press key " " (T3) to exit the configuration or wait 20 seconds.
Quit and give power voltage to the system to start the unit under the new config-
uration.
ID Name
Configuration
CF
bU Bus Protocol
Ad Unit Address
Fa Fancoil Type
Po Position of installation
Temperature
co
compensation
" or " " (T1) until you select the desired parameter
" or " " (T1) to scroll the list of parameters: CF -> bU -> Ad -> Fa -> Po -> co ->
" (T2) for more than 3 seconds to change the value (Display blinking)
" (T2) to scroll the possible values of the parameters
Description
Configure the type of control
Allows to configure the type of bus used
Allows to set/change the unit address
(insert the value in hexadecimal format)
Allows to select the type of fancoil
Allows to select where the fancoil has
been installed
Allows to choose the compensation
value to use
" (T2) and " " (T1) for at least 5 seconds,
Permitted values
AU : Autonomous
rE : Remote
AS : ASCII
rt : RTU
00 -> FF (255)
_0: Without flap (200-1000)
_1: All versions (1400-1600)
_2: With flap (200-1000)
uP : roof installation
dO : floor installation
-5 : 5
Bi2 WALL TR 1000 - 1200 - 1400
EN - 13