Publicidad
Idiomas disponibles
Idiomas disponibles
- The alternate switching on of the red and blue LEDs (A5) indicates that the automatic cooling/heating
mode is active.
- The 4 LEDs "
mode is active.
Each of these LEDs is active in blinking mode (soft-blinking) if during heating or cooling (red or blue LEDs
"A5" ON) the set temperature is respectively lower or higher than the ambient temperature detected by
the appliance.
To increase comfort at night, the LEDs brightness on the electronic panel is decreased after 15
seconds of inactivity on the keys or on the temperature selector.
Only from remote controller, press key "B7" to be able to switch off the LEDs on the control panel after 15
seconds of inactivity on the keys.
Every time the keys are pressed on the control panel, the LEDs brightness returns at maximum level over
the following 15 seconds.
7.11 - SWING OPERATION
a. Press the key "B3", the icon (D9) lights up and the flap starts to oscillate. Press key "B3" again, the icon
(D9) switches off and the flap stops oscillation, stopping in the position it reached at that moment (Fig.19).
If the fan is switched off while the flap is set to swing mode, the swing stops and restarts when
the fan is switched on again.
This function can only be activated/deactivated from the remote controller.
7.12 - SPECIAL FUNCTIONS
7.12.a -
Air sampling
In heating or cooling mode and with ambient temperature higher or lower than the desired value, the fan
is periodically powered for 1 minute at minimum speed. This way, the system is able to adequately keep
temperature in the room under control and to reactivate faster in case of need.
This function is ONLY active if the unit is installed in high position.
7.12.b -
Commands lock
To lock the keys on board the machine, keep keys "
The activation of the function is verified by the visualization of (BL) on the display every time any key is
pressed.
This function can only be activated/deactivated from board the machine.
7.12.c -
Water not suitable
The effective operation of the appliance in cooling or heating mode is always conditioned by temperature
of water circulating inside the system. If water temperature does not reach a value suitable for the set
mode, so if water is too hot in cooling mode or too cold in heating mode, the fan motor remains off and
the indicator of the current mode (A5) blinks.
- The function is active in cooling mode if the unit is not thermostatic and if water temperature in the
battery is higher than 20°C from more than 5 minutes.
The unit immediately resumes normal operation of one of the two conditions is not met anymore.
EN - 20
", "
", "
" and "
" indicate the set fan speed. If all the 4 LEDs are off, Stand-by
" (T1) pressed simultaneously for 5 seconds.
Publicidad
