Publicidad
Idiomas disponibles
Idiomas disponibles
6.5 Nozzle regulation
This sprayer is supplied with adjustable nozzle F1.
Screwing or unscrewing the final part of the nozzle F1, it is
possible to adjust the diameter of the "rose" spray until you get
the "jet" (fig.7).
ADJUSTABLE BRASS NOZZLE FOR SPRAYING (COD. 928)
Pressure (bar)
Flow rate (lt/min)
5,0
0,60
4,0
0,54
3,0
0,49
2,0
0,44
6.6 Operations to be carried out at termination of work
When finishing work, pour the remaining liquid in a specific
container and carefully rinse the inside of the tank with clean,
cold water. Let the water flow through the hose and lance.
Check that the water used for rinsing has completely come out.
Turn off the pump by turning knob W counterclockwise and
check that led Z is off.
After having cleaned the tank, remove, clean and reassemble
the filters (Q and P).
Unscrew the nozzle F1 from the lance F-G; disassemble the
nozzle and clean the two parts with clean water, paying attention
not to damage or loose the o-ring.
Clean the handle using a damp cloth without soaking it in water.
Unscrew the nut D1; remove the hose from its holder; remove
the hose holder with filter and wash it with clean water; then,
reassemble all the parts.
Remove from the tank eventual materials or objects that could
damage the sprayer.
Wear clothes and protective devices during these activities.
Warning! Do not disperse the rinsing water or the remaining
solution in the environment; it is recommended to pour all these
liquids in specific drains, suitable for water purification and drainage.
Turn off the pump by turning knob W counterclockwise and
check that led Z is off after every use.
Keep the sprayer out of reach from children, protected from
direct sunlight and cold temperatures and with completely
charged battery.
6.7 Change of liquid in the tank
In case a change of the liquid inside the tank is necessary, follow
the instructions given in point 5.6 and after that, the instructions
in point 5.2.
7 Maintenance
7.1 Introduction
A correct use of the sprayer and a regular maintenance are
necessary to keep the sprayer in the best working, efficacy and
(Translation from the original instructions)
safety conditions.
Use exclusively original spare-parts.
7.2 Battery recharge
The sprayer is powered by an integrated battery, rechargeable
with the supplied battery charger N.
Warning! During charging operations, adopt safe working
procedures and observe safety regulations.
In order to recharge the battery, follow these instructions:
Sprayable liters for each
battery charge
Š Turn off the sprayer by turning the knob W
75
counterclockwise and check that led Z is off.
85
Š Check that the network voltage corresponds to the
indication printed on the battery charger plate N.
90
Š Connect the battery charger N to a suitable and electrically
95
protected socket.
Š Insert the battery charger plug into the S slot on the
sprayer base.
Š Monitor charging via the battery charger LED indicator
(red light in charge, green light end of charge).
Š It takes about 2 hours to fully recharge the battery.
Š At the end of the charge it is recommended to disconnect
the battery charger from the socket first and then from the
S slot on the sprayer base.
Š During long periods of inactivity, check that the led Z is off.
The battery life mostly depends on the observance of some
important rules:
Š Do not create short-circuit.
Š Do not discharge it excessively: when the battery is almost
discharged, charge it immediately.
Š Promptly recharge it with the general on/off switch turned
off and respecting the necessary charging time.
Š For the recharge use only the battery charger supplied
with the sprayer.
Š Do not turn the sprayer on when the battery charger is
connected.
Š After the complete recharge, keep the sprayer between
5 and 40° C.
Š In case of long stocking or non-use, recharge the battery
every four months.
When the battery is no longer rechargeable, contact the
authorised service centre for the replacement.
ENGLISH
EN
5
IT
BG
CS
DA
DE
EL
ES
ET
FI
FR
HR
HU
LT
LV
NL
NO
PL
PT
RO
SK
SL
SV
TR
UA
Publicidad
