Publicidad
Idiomas disponibles
Idiomas disponibles
5.4
Opening the product
The tasks described in this section may only
be carried out by a qualified electrician.
2.
1.
Fig. 4: Detach front cover
Fig. 5: Opening the product
In the delivery state, the front cover is not fitted and
the top section of the housing is not screwed down.
The front cover and screws are included in the
scope of delivery.
u If necessary, Unscrew the front cover using a
slotted screwdriver (4mm).
u Unscrew screws if necessary.
u Flip down the top section of the housing.
16
5.5
Installing the product on the wall
5.5.1 Creating drill holes
ATTENTION
Material damage due to uneven surface
Installing on an uneven surface can cause the hous-
ing to go out of shape, so that the protection class
is no longer guaranteed. Consequential damage of
electronic components can occur.
u Only install the product on an even surface.
u If necessary, level out uneven surfaces with
suitable measures.
MENNEKES recommends installing at an er-
gonomically sensible height depending on
the height of the body.
ATTENTION
Material damage due to drilling dust
Consequential damage of electronic components
can occur if drilling dust gets into the product.
u Make sure that drilling dust does not get into
the product.
u Do not use the product as a drilling template
and do not drill through the product.
Publicidad
