Publicidad
Idiomas disponibles
Idiomas disponibles
n If the product is not configured for the
"Solar charging" and "Solar-assisted
charging" charging modes, the buttons
have no function.
For the 22 kW variants and the 11 kW vari-
ants with activated dynamic phase
changeover, the following applies:
n It is possible to switch between the "Fast
charging", "Solar charging" and "Solar-
assisted charging" modes at any time
(even during active charging).
For the 11 kW variants with deactivated dy-
namic phase changeover, the following ap-
plies:
n It is possible to switch between the "Fast
charging", "Solar charging" and "Solar-
assisted charging" modes at any time
(even during active charging).
n It is not possible to switch between the
"Fast charging" and "Solar charging" or
"Solar-assisted charging" charging
modes during an active charge. The
vehicle must be disconnected from the
charging station before switchover.
6.2.4 Energy management system
The tasks described in this section may only
be carried out by a qualified electrician.
The product can be connected to an energy man-
agement system via Modbus RTU as needed to
complete complex application cases. The product is
controlled by the energy management system
(master).
30
Information on compatible energy manage-
ment systems and the description of the
Modbus RTU interface (Modbus RTU Re-
gister Table) can be found on our website:
www.mennekes.org/emobility/knowledge/
compatible-systems-and-interfaces
Publicidad
