Publicidad
Idiomas disponibles
Idiomas disponibles
English
Tips and suggestions
PROBLEM
The induction hob cannot
be switched on.
Touch controls do not
respond.
Touch controls are difficult
to operate.
The glass is scratching.
Some frying pans make
crackling or popping
noises.
The induction cooktop
emits a slight buzzing
sound when used on
a high heat setting.
Fan noise from the
induction hob.
The pans do not heat up
and appears on the
display.
The induction hob or a
cooking zone has been
switched off
unexpectedly, a tone
sounds and an error
code is displayed.
(usually alternating
with one or two digits on
the display of the cooking
timer).
152 Pando
Integral Cooking
POSSIBLE CAUSES
There is no power.
The controls are locked.
There may be a slight film of
water on the controls.
Kitchen utensils with rough edges.
Not suitable, abrasive scouring pad
or cleaning products
used.
This may be due to the
construction of your cookware
(layers of different metals
vibrating together in a
different).
This is due to the
technology of induction
cooking.
The cooling fan integrated in
your induction cooktop has
been switched on to prevent
the electronic components from
overheating.
switch off.
The induction hob cannot
detect the frying pan because it
is not suitable for induction
cookers. The induction hob does
not detect the frying pan
because it is too small for the
cooking zone. or is not well
focused on it.
Technical failure.
WHAT TO
Make sure that the induction hob is connected to the
power supply.
and that it is switched on.
Check for power, (power outage in your home or area) If
you have checked everything and the problem persists,
call a
qualified technician.
Unlock the controls. See section "Refer to the
instructions for use of the induction hob".
Make sure the touch control area is dry and use your
fingertip when touching the controls.
Use cookware with flat, smooth bases. See "Cooking tips" -
See "Care and cleaning".
This is normal for kitchen utensils and
does not indicate a fault.
This is normal, but the noise should attenuate or disappear.
completely by reducing the heat setting.
This is normal and does not require any action. Do not
disconnect the induction hob power supply from the wall
while the fan is operating.
Use cookware that is suitable for use in the cooker.
induction. See section "Cooking tips".
Centre the pan and ensure that the base of the pan
matches the size of the cooking zone.
Note the error letters and numbers, change the power
supply to the induction hob on the wall, and contact a
PANDO SAT
.
MUST BE PERFORMED BY A PANDO
ANY DAMAGE OCCURS DURING
SAT SPECIALIST IF
THIS PROCESS THAT
A USER OR A PANDO SAT SPECIALIST, PLEASE
CONTACT A PANDO TAS.
UNAUTHORISED PERSONNEL WILL NOT BE
COVERED BY THE WARRANTY, EVEN IF IT IS
STILL VALID!
Pando Induction hob
DO
HAS BEEN CARRIED OUT BY
GB
Publicidad
