Pando PI-3110 Manual De Instalación página 164

English
This hob must only be connected to the mains
by a suitably qualified person.
Before connecting the hob to the mains, check
that:
1. The domestic electrical installation is suitable
for the power consumed by the hob.
2. The voltage corresponds to the value indicated
on the rating plate.
3. The power cable cross-sections can withstand
the load specified on the rating plat
When connecting the hob to the mains,
do not use adapters, reducers or shunts,
as these can cause overheating and fire.
The power cable must not touch any hot parts and
must be positioned so that its temperature does
not exceed 75˚C at any time.
Web
220-240V~ 50-60Hz
220-240V~ 50-60Hz
400V~ 50-60Hz
164 Pando
Integral Cooking
Mains Power Board Connection
Connec�on
L1+N1
L1+N
L2+N2
L2+N
L1&L2+N1&N2
L1&L2+N
L1+L2; N1&N2
L1+L2; N1
Check with an electrician whether the do-
mestic wiring system is suitable without
Any modifications must only be carried out
by a qualified electrician or SAT PANDO.
• If the cable is damaged or needs to be repla-
ced, the operation must be carried out by the
after-sales agent with specific tools to avoid
any accidents.
• If the appliance is connected directly to the
mains, an omnipolar circuit breaker with an
opening of at least 3 mm between the con-
tacts must be installed.
• The installer must ensure that the correct
electrical connection has been made and that
it complies with safety regulations.
• The cable must not be bent or compressed.
• The cable must be checked periodically and
replaced by authorised technicians.
The bottom surface and the power cable
The bottom surface and the power cable of
must not be accessible after installation.
Ø Cable
5x1.5mm^2
H07RN-F
5x2.5mm^2
4x2.5mm^2
Pando Induction hob
alterations.
the cooktop must not
installation.
Protec�ve gauges
16A
32A
16A