Champion Global Power Equipment 100304 Manual Del Operador página 15

100304 - 22-kW HOME STANDBY GENERATOR WITH AXIS CONTROLLER
Component Identification – Engine
1
5
1. Engine Oil Dipstick
2. Air Cleaner
3. Oil Cap
4. Spark Plug (second on opposite side)
5. Oil Filter
Control Panel
MAIN CIRCUIT BREAkER
The 100-amp main circuit breaker protects the generator from
circuit overload. The main circuit breaker controls total output of
the generator. The main circuit breaker must be in the ON position
for the aXis ATS to communicate with this standby generator.
MAIN CIRCUIT BREAKER
ON
OFF
2
3
4
®
GENERATOR ON/Off SWITCH
If maintenance or service work is going to be performed on the
generator or the home's electrical system, accidental startup
is further safeguarded by pulling out the fuse from the aXis
Controller panel and disconnecting the batteries.
®
This generator has ON/OFF switches that when turned off, will
shut down the HSB (if running) and deactivate the aXis Controller
preventing future starts. These switches should be used in
instances where the HSB needs to stay off regardless of utility
power presence. When either switch is in the OFF position, the
HSB will not exercise or start for any reason.
When both of the switches are in the ON position, the aXis
Controller will be energized and the HSB will be controlled by the
®
programming of the aXis Controller
the ON position in order for the HSB to operate in AUTO mode.
N OTE:
Both switches need to be in the ON position to place the
aXis Controller
the HSB.
Inside
MICROSWITCH
There is a microswitch located behind aXis Controller
microswitch prevents accidental starting while accessing this
area.
15
GENERAL INfORMATION
NOTICE

. Both switches need to be in
®
in the AUTO mode and in order to exercise
®
Back
ON
OFF
®
ON
OFF
panel. This
®