100304 - 22-kW HOME STANDBY GENERATOR WITH AXIS CONTROLLER
Wi-fi Setup Method
1. Use a Wi-Fi enabled device (laptop, smart phone, tablet, etc.)
in near proximity to the ATS.
2. Search and connect to network name (SSID) "Champion
####" where #### will match the last four digits of the serial
number that is printed on the control board.
2a. The password for the network is located on a label on the
dead front of the ATS.
PASSWORD
CONTRASEÑA
MOT DE PASSE
12345678
During the setup your device will disconnect from the internet.
The Champion Wi-Fi is a direct connection between your
device (laptop, smart phone, tablet, etc.) and the ATS, and it
Wi-fi
does not connect to the internet. Some Android devices may
show the following screen – Choose "Connect only this time."
On
Internet may not be available.
If you want to connect this network without
internet access, you can connect only this
time or you can set your phone to always
connect to it even if internet isn't available.
You can change this in Settings >
Connections > Wi-fi > ADVANCED >
Switch to mobile data > Network
exceptions
Connect only this time
PASSWORD
CONTRASEÑA
MOT DE PASSE
12345678
NOTICE
Allow switch
Stay connected
®
3. After connecting Wi-Fi, open your device's web browser. In
the browser address change the address to 192.168.0.90 and
begin search. This will direct your browser to the Champion
aXis Controller
Home Standby Generator Settings page
®
located on the ATS. If your device's web browser does not
load the Champion aXis Controller
Settings Page but rather stays connected to the internet, turn
off mobile data on the device (if applicable) and make sure
the device is not connected to any other networks.
192.168.0.90
4. On the Champion aXis Controller
Settings Page, set the date and time. Use either the dropdown
boxes or the "USE THIS DEVICE DATE & TIME" button to set
Generator Date and Time
the time and date.
USE DEVICE DATE & TIME
Date:
Time:
20
GENERAL INfORMATION
Home Standby Generator
®
Home Standby Generator
®
Choose Month...
Choose Date...
Choose Year...
Choose Hour...
Choose Minute...
Choose AM/PM...
CONFIRM DATE & TIME