Champion Global Power Equipment 100304 Manual Del Operador página 22

100304 - 22-kW HOME STANDBY GENERATOR WITH AXIS CONTROLLER
9. Wireless network settings are not used at this time. The
default values (shown below) should not be adjusted.
Adjustment of this factory settings will require a certified
electrician to correct.
Wireless Network
Internet Service:
Direct Connect
OK
Web Page Mode:
AP Mode
AP Mode IP : 192. 168. 0. 90
CONFIRM NETWORK SETTINGS
10. The time, date, and exercise information have now been
setup for the aXis ATS and HSB. You can close your browser
and disconnect from the ATS Wi-Fi, or skip to step 2 in the
next section "ATS and HSB STATUS USING WI-FI"
ATS and HSB Status Using WIfI
1. Using a WIFI enabled device, connect to the "Champion HSB"
WIFI network following steps 1, 2, and 3 from WIFI Setup
Method.
2. After loading the Home Standby Generator Settings page,
locate and click the
page.
3. You are now viewing the ATS and HSB status page. Items
such as voltage, frequency, current, etc. can all be viewed for
both utility and HSB power. All of the information is live. There
are three tabs located at the top of the page.
ATS, GEN, and LMM. Each tab will display the status for
the Transfer Switch, Home Standby Generator, or Load
Management Module(s) respectively.
4. When finished viewing the status of the ATS, Generator, and
LMM, close your browser and disconnect from the WIFI.
CANCEL SETTINGS
icon at the bottom right corner of the
®
Programming aXis Controller
Setting values are not autosaved. You must press OFF to save
the changes and exit the programming.
Please wait for the decimal point to stop flashing before
moving on to the next function. If you hit
decimal point is still flashing, it does not save the change.
1. To begin programming, disable AUTO by selecting OFF
2. After the HSB is set to OFF, press and hold
changes (decimal point will flash) to enter programming
mode. The display will show YA for year and the clock icon
will illuminate.
Please wait for the decimal point to stop flashing before
moving on to the next function. If you hit
the decimal point is still flashing, it doesn't save the change.
3. Year (Y) - choose current year (example 2021 would be 21)
with 18 to 47.
Set year using
MODE
for next
4. Month (M) - choose January to December with 1-12.
Set month using
MODE
for next
5. Day (D) - choose the day from 1 to 31.
Set day using
MODE
for next
6. Week Day - choose week day from 1 to 7.
Set week using
MODE
• 1= Monday
• 2= Tuesday
• 3= Wednesday
• 4= Thursday
• 5= Friday
22
GENERAL INfORMATION
®
NOTICE

too soon while the
until the screen
too soon while
.
OFF
ARRÊT