Publicidad
Idiomas disponibles
Idiomas disponibles
Cleaning
Cleaning
CLEANING INSIDE - OUTSIDE
• Self-cleaning of the cavity by pyrolysis
Warning
Remove the accessories and wire tiers from the oven before starting a pyrolysis cleaning.
Before starting a pyrolysis cleaning of your oven, remove any large overflows that may have
occurred. Remove excess grease from the door with a damp sponge.
For safety reasons, the pyrolysis cleaning operation is only carried out after the door has been automati-
cally locked, the door cannot be unlocked.
• Immediate self-cleaning
The timer should display the time of day, without flashing. Select one of the self-cleaning cycles with the
+ or buttons -. Confirm your choice with OK .
Cleaning in 39 minutes
- At the end of each firing, "Clean 39" flashes on the display, prompting you to start cleaning. Go to the
cleaning menu and confirm "Clean 39". The time 0:39 is displayed alternately with "Clean 39", your clea-
ning starts. After a few minutes a key will appear, the oven door will be locked automatically for safety
reasons during the entire programme. If you want to start a "Clean 39" program, the oven is cold or not
hot enough, the program start conditions will not allow this cleaning. 0:00 will appear on the display, you
will have to choose one of the other cleaning functions.
Pyrolysis of 2 hours or 1.5 hours, as desired.
Select one of the two cleaning functions depending on how dirty your oven is.
Depending on your choice, the time 2:00 (or 1:30) is displayed. Confirm with the OK button.
The pyrolysis starts.
At the end of the cleaning process, the display shows cooling and pyrolysis completed and the door is
unlocked.
• Delayed self-cleaning
You can delay the start of your Pyrolysis programme. When the programme duration appears on the
display, select
cleaning process will start later and end at the new set time.
20
CLEAN39'
and set the new end time with the + and - buttons and confirm with OK. The self-
CLEAN39'
Publicidad
