Publicidad
Mounting of PLUS FAN
Mounting of PLUS FAN
7. INSTALLATION OF VANVENT
DE
1.Open mounting holes for the PLUS FAN on the roof (strong wall with a width ≥30mm is
NOTE:
We recommend installation by qualified personnel. Ask your dealer to install the
required around the hole to ensure that the self-tap screw can be firmly nailed into that
1.Open mounting holes for the PLUS FAN on the roof (strong wall with a width ≥30mm is
wall) according to the hole size drawing on the [Mounting Dimensions] page. Power cord
required around the hole to ensure that the self-tap screw can be firmly nailed into that
VanVent if you do not have sufficient installation knowledge.
EN
wall) according to the hole size drawing on the [Mounting Dimensions] page. Power cord
≥50mm can be optionally reserved in the opening on the left or right side of the body.
≥50mm can be optionally reserved in the opening on the left or right side of the body.
IT
ES
R5
R5
FR
NL
The outlet on the left side of the vehicle body is taken as an example in this manual.
The outlet on the left side of the vehicle body is taken as an example in this manual.
FI
The outlet on the left side of the vehicle body is taken as
2.Take out the vehicle body fixing plate from the package, and inject sealant (MS type
2.Take out the vehicle body fixing plate from the package, and inject sealant (MS type
an example in this manual.
sealant recommended) into the rubber groove of the outer ring of the vehicle body
sealant recommended) into the rubber groove of the outer ring of the vehicle body
DK
fixing plate frame. The sealant should not be too much, and any excessive glue should
fixing plate frame. The sealant should not be too much, and any excessive glue should
be cleaned up with a soft scraper.
be cleaned up with a soft scraper.
SE
Mounting of PLUS FAN
The amount of sealant should be even. Do not apply too
The amount of glue should be even. Do not apply too much glue.
much sealant.
3.Fix the body fixing plate on the wall of the motor home with ST4.2×25 cross pan-head
The amount of glue should be even. Do not apply too much glue.
screws (16 pcs) outside the body. After fixing the screws, remove excessive glue around
the body fixing plate, if any.
The fixing screw must be fixed firmly.
The fixing screw must be fixed firmly.
4.Remove the upper part of the PLUS FAN top cover, align it with the body fixing plate
frame, and insert the upper part into the frame. After pressing, apply an appropriate
amount of sealant (recommended to use MS type sealant) to (PT4.0 × 12 (4)), and then
use screws to fix the upper part of the body fixing plate.
12 V
20
CARBEST VanVent | 318028/318029
1.
Before installation, check the
roof thickness, which should
be between 27 mm and 80
mm. Mark the cut-out opening
(400x400 mm) on the roof and
cut the hole in the roof.
12 V power cord ( >=50 mm)
from vehicle battery can be
reserved in the opening on the
left or right side.
2.
Before installing the VanVent,
the surface must be cleaned
(free of dust and grease). Apply
a sufficient amount of appro-
priate adhesive (recommended
DEKAseal 8936) around the
edge of the mounting frame.
13
3.
13
Fix the mounting frame to
the roof of the vehicle using
ST4.2x25 cross head screws
(16 pcs.).
Remove excess adhesive.
Publicidad
