Publicidad
Mounting of PLUS FAN
7.Connect the harness terminals (3 types) of the upper and lower assemblies of PLUS FAN
respectively, and connect the anode and cathode of the power cord.
DE
EN
IT
ES
The wiring harness shall be neat, and all terminals shall be connected firmly without any
insufficient or omitted connection. The wiring harness shall be aligned in color, and fixed with
cable ties after wiring harness arrangement.
FR
8.Place the spring and the transmission square shaft into the manual knob groove of the
PLUS FAN in turn.
The wiring harness shall be neat, and all terminals shall be connected firmly without any
NL
insufficient or omitted connection. The wiring harness shall be aligned in color, and fixed with
cable ties after wiring harness arrangement.
Fyrkantsaxel för
drivning
8.Place the spring and the transmission square shaft into the manual knob groove of the
PLUS FAN in turn.
FI
Vår
Handratt
DK
SE
Mounting of PLUS FAN
9.After arranging the wire harness, align the square shaft with the corresponding position
of the upper assembly of the top cover, insert the lower assembly of the interior trim
frame of the PLUS FAN , and screw the ST3.9×40 cross pan-head screws (4 pcs) into the
corresponding holes in turn.
The spring shall be free from damage, the handle shall rotate flexibly without stagnation,
and the square shaft shall be clean and free from oil stain and other sundries.
The spring shall be free from damage, the handle shall rotate flexibly without stagnation,
and the square shaft shall be clean and free from oil stain and other sundries.
16
16
Harness shall be neat and all terminals shall be connected firmly without insufficient or
Kabelnätet ska vara snyggt och alla terminaler ska vara
omitted connection. Screws shall be fixed firmly.
ordentligt anslutna utan otillräcklig eller saknad anslutning.
10.Insert the lamp covers laterally into the corresponding slots in the lower assembly of
Skruvar ska vara ordentligt fastsatta.
the PLUS FAN trim frame.
CARBEST VanVent | 318028/318029
6.
Anslut utomhusenhetens tre
kontakter till motsvarande mot-
stycken på inomhusenheten.
Strömkabeln (röd/svart) måste
anslutas till fordonets 12 V
elsystem.
7.
Placera fjädern och drivfyr-
kantsaxeln i VanVents manuella
vred. Välj lämplig drivfyr-
kantsaxel beroende på takets
tjocklek:
Drivaxel 120 mm lämplig väg-
gtjocklek: 27-47 mm
Drivaxel 140 mm lämplig väg-
gtjocklek: 48-67 mm
Drivaxel 160mm lämplig väggt-
jocklek: 68-80mm
8.
Efter att ledningsnätet har
placerats, rikta in den fyrkan-
tiga axeln med motsvarande
position på utomhusenheten
och skruva in ST3.9×40-
korsskruvarna (4 st.) i mots-
varande hål en efter en.
92
Publicidad
