Publicidad
Mounting of PLUS FAN
7.Connect the harness terminals (3 types) of the upper and lower assemblies of PLUS FAN
respectively, and connect the anode and cathode of the power cord.
DE
EN
IT
ES
The wiring harness shall be neat, and all terminals shall be connected firmly without any
insufficient or omitted connection. The wiring harness shall be aligned in color, and fixed with
cable ties after wiring harness arrangement.
FR
8.Place the spring and the transmission square shaft into the manual knob groove of the
PLUS FAN in turn.
The wiring harness shall be neat, and all terminals shall be connected firmly without any
NL
insufficient or omitted connection. The wiring harness shall be aligned in color, and fixed with
Firkantet aksel til drev
cable ties after wiring harness arrangement.
8.Place the spring and the transmission square shaft into the manual knob groove of the
Forår
PLUS FAN in turn.
FI
Håndknap
DK
SE
Mounting of PLUS FAN
9.After arranging the wire harness, align the square shaft with the corresponding position
of the upper assembly of the top cover, insert the lower assembly of the interior trim
frame of the PLUS FAN , and screw the ST3.9×40 cross pan-head screws (4 pcs) into the
corresponding holes in turn.
The spring shall be free from damage, the handle shall rotate flexibly without stagnation,
and the square shaft shall be clean and free from oil stain and other sundries.
The spring shall be free from damage, the handle shall rotate flexibly without stagnation,
and the square shaft shall be clean and free from oil stain and other sundries.
16
16
Harness shall be neat and all terminals shall be connected firmly without insufficient or
Ledningsnettet skal være pænt, og alle terminaler skal
omitted connection. Screws shall be fixed firmly.
være solidt forbundet uden utilstrækkelig eller manglende
10.Insert the lamp covers laterally into the corresponding slots in the lower assembly of
forbindelse. Skruerne skal sidde godt fast.
the PLUS FAN trim frame.
CARBEST VanVent | 318028/318029
6.
Tilslut udendørsenhedens tre
stik til de tilsvarende mod-
stykker på indendørsenheden.
Strømkablet (rød/sort) skal
tilsluttes køretøjets 12 V-el-
system.
7.
Placer fjederen og firkantakslen
i VanVents manuelle drejeknap.
Vælg en passende firkantet
drivaksel i forhold til tagets
tykkelse:
Firkantet drivaksel 120 mm
egnet vægtykkelse: 27-47 mm
Firkantet drivaksel 140 mm
egnet vægtykkelse: 48-67 mm
Firkantet drivaksel 160 mm
egnet vægtykkelse: 68-80 mm
8.
Når du har placeret led-
ningsnettet, skal du justere
den firkantede aksel med
den tilsvarende position på
udendørsenheden og skrue
ST3.9×40-krydshovedskruerne
(4 stk.) i de tilsvarende huller
en efter en.
82
Publicidad
