Roger Technology ROGER BRUSHLESS B70/1THP Instrucciones Y Advertencias Para El Instalador página 70

(1)
enable the command. Example: parameters
•
seconds by pressing CHB on the remote control. Press CHB to activate partial opening.
Selecting courtesy light mode
Disabled.
ACTIVE. The light remains lit for the entire duration of the manoeuvre.
From 3 to 90 s. The light remains lit for the time period set after the manoeuvre is completed.
From 2 to 9 minutes. The light remains lit for the time period set after the manoeuvre is completed.
When the clock function is active, the gate opens and remains open.
At the end of the programmed time set with the external device (clock), the gate closes.
When the clock function is active, the gate opens and remains open. Any command signal received is ignored.
When the clock function is active, the gate opens and remains open. Any command signal received is accepted. When
the gate returns to the completely open position, the clock function is reactivated.
Enable safeguarded gate closure/opening
Enabling this parameter ensures that the gate is not left open due to an incorrect and/or accidental command.
This function is NOT enabled if:
• the gate receives a STOP command;
•
the sensitive edge intervenes, detecting an obstacle in the same direction in which the function is enabled. If instead the
sensitive edge detects an obstacle during the movement opposite to the one guaranteed, the function remains active.
• the number of closure attempts set by parameter
• the acquired position is lost (perform position recovery, see chapter 21).
Disabled. The parameter
Enabled.
After a period of time set with parameter
less of the parameter
Enabled.
If the gate is closed as a result of a step mode command, after a period of time set with parameter
If the gate is stopped by the obstacle detection system during a closure manoeuvre, the gate closes after a period of
time set with parameter
If the gate is stopped by the obstacle detection system during an opening manoeuvre, the gate closes after a period of
time set with parameter
Setting safeguarded closure/opening activation time
N.B.: this parameter is not visible if the value of parameter
Wait time settable from 2 to 90 s.
Wait time settable from 2 to 9 min.
Selection of the battery operation management
Setting a value different than
via parameter
The control unit always accepts commands until the battery is completely exhausted.
The command becomes active when the battery voltage drops to the minimum threshold (22V
36.4V
The command becomes active when the battery voltage drops to the medium threshold (23V
36.8V
The command becomes active when the battery voltage drops to the maximum threshold (24V
37.2V
70
(1)
and
is not displayed.
, and then closes the gate.
.
.
a battery voltage level check is activated. The desired operation type can be selected
and an error alert can be activated through the COR output via parameter
)
)
)
set:
has been reached;
), and then the gate closes.
= .
-
, the control unit
.
with B71/BCHP charger;
with B71/BCHP charger;
with B71/BCHP charger;