13
Special parameters for Reversible series
The Reversible (/R) series is a family of digital brushless motor units for sliding gates weighing up to 1200
kg (TW110/1200/R) and dedicated exclusively to residential and industrial applications.
REVERSIBLE technology makes it possible to open and close the gate without releasing the motor even in
the event of power failure. When the gate is moved manually, in the absence of supply voltage, the rotation
of the motor provides power to the control unit the display lights up and the message '
handle the gate by hand with moderation.
The control unit allows independent management of speed, acceleration, deceleration and the safety devices used in
the system.
impede manual movement of the gate.
As a result, prolonged operation may drain the battery when operating under battery power.
3 cm is detected, the control unit initiates a position recovery procedure (see chapter 21).
NOTE: Even though it is a REVERSIBLE unit, the motor is equipped with a lock release system.
The additional parameters for enabling REVERSIBLE technology are indicated as follows.
Selecting automation system model
ATTENTION! The value of parameter
NOTE: in the case of resetting to the standard factory parameters, the value of the parameter is not changed.
TW110/2000
TW110/1000/HS
TW110/1600/HS
TW110/1200/R
Setting deceleration during opening
Setting deceleration during closing
= the gate decelerates near the mechanical stop/limit switch ...
stop/limit switch.
Setting start acceleration during opening
Setting start acceleration during closing
= the gate accelerates rapidly at start of manoeuvre ...
manoeuvre.
Setting opening speed
N.B.:
Setting closure speed
N.B.:
= 6 m/min ...
N.B.: to set the constant speed deceleration space, see parameters
74
is set at the factory to select the motor model (
= maximum speed.
, see table below). If this value
= the gate decelerates long before the mechanical
= the gate accelerates slowly and progressively at start of
and
on chapter 12.
' appears. WARNING!