Corghi HD 700 Manual De Usuario página 48

WHEEL LOCKING
INSTRUCTIONS
CAUTION
During the clamping phase, make sure
that the clamps are positioned correctly
on the rim to prevent the wheel from
falling.
1) Move the mobile control unit to work-
ing position B.
2) Tilt the tool holder arm to the non-working
position.
3) Use the control lever to move the mobile
platform away from the turntable and raise the
wheel, keeping it in a vertical position.
CAUTION
This operation can be extremely dan-
gerous!
Perform it manually if you are absolutely
certain you can maintain the wheel equi-
librium only.
For heavy, large sized wheels you MUST
use a suitable lifting device.
4) Always using the control level, raise or lower
the turntable holder arm until centring the turn-
table as much as possible with the rim.
5) With the clamps in a closed position, move
the wheel towards the turntable, moving the
mobile platform, then use the switch to open
the turntable, then clamp the rim internally and
in the best position that is selected base on the
rim type, as shown in figures 13A -13B - 13C
- 13D 13E - 13F.
Please remember that clamping on the
central flange is always considered the
safest approach.
N.B.: for wheels with a rim well, clamp the rim
so that the well is located on the outer side
(see fig. 13A).
48
13A
13C
13E
CAUTION
Never leave your work station with the
wheel clamped on the turntable and
lifted off the ground.
- E - Operator's manual HD 700
nglIsh
13B
13D
13F