Corghi HD 700 Manual De Usuario página 50

TUBELESS AND
SUPERSINGLE
WHEELS
BEAD BREAKING
1) Clamp the wheel on the turntable, as
previously described, and ensure that it is
deflated.
2) Move the mobile control unit to work-
ing position C.
3) Lower the tool holder arm into its working
position until it hooks with the ratchet.
CAUTION
Always make sure that the arm is cor-
rectly hooked to the carriage.
4) Using the control lever, position the wheel
so that the external rim profile skims the bead
breaker disc (fig.19).
CAUTION
The bead breaker disc must not press against
the rim but the tyre bead.
50
5) Rotate the wheel and, at the same time, ad-
vance the bead breaker disc with small forward
movements, following the rim profile as much
as possible with the disc.
6) Continue until the first bead is completely
detached.
To facilitate the operation, lubricate the bead
and the shoulder of the rim using the specific
grease or a soapy solution, keeping the wheel
in movement.
CAUTION
To avoid all risk, lubricate the beads
turning the wheel CLOCKWISE if you are
working on the outer side or ANTICLOCK-
WISE if working on the inner side.
N.B.: remember that the disc must be moved
forward more slowly in relation to the tyre
greater adherence to the rim.
7) Move the tool holder arm away from the
rim edge.
Release the ratchet, raise the arm to its non-
working position, shift it and rehook it in its
second working position (fig.20).
A
19
CAUTION
Never hold onto the tool with your hand
when moving it to the working position:
- E - Operator's manual HD 700
nglIsh
20
B