Corghi HD 700 Manual De Usuario página 57

the rim, 5 mm. away from it (see Fig. 30).
11) Move the mobile control unit to
working position C.
12) Move to the outside of the wheel and
visually check the exact position of the tool
and adjust it as needed. Then turn the turnta-
ble clockwise until the gripper is at the lower
point (6 o'clock).
The first bead will be inserted in the rim.
Remove the gripper.
13) Move the mobile control unit to
working position D.
14) Remove the tool from the tyre.
15) Move the tool holder arm to the non-
working position; move it to the outer side of
the tyre.
16) Turn the tool 180° using the tool rotation
lever.
17) Move the mobile control unit to
working position B.
18) Turn the turntable until the valve hole is
at the lower point (at 6 o'clock).
19) Move the mobile platform under the wheel
and lower the turntable until the turntable rests
on the platform.
- E - Operator's manual HD 700
nglIsh
Move the platform outward to create space
between the tyre and the rim into which the
inner tube can be inserted.
N.B.: The valve hole may be asymmetri-
cal to the centre of the rim. In this case
position and insert the inner tube as
shown in fig. 31.
Insert the valve through the hole and fix it with
its ring nut.
30
20) Place the inner tube in the rim well.
N.B.: To facilitate this operation, turn the turn-
table at the same time clockwise.
21) Turn the turntable until the valve is at the
bottom (at 6 o'clock).
22) Inflate the inner tube a little (until it has
no folds) so as not to pinch it while mounting
the second bead.
23) Attach an extension to the valve and then
remove the fastening ring nut.
N.B.: The purpose of this operation is to allow
the valve to be loose and not be ripped out
when the second bead is mounted.
24) Move the mobile control unit to working
position C.
25) Lift the wheel again and attach the rim grip-
per outside the second bead, approx. 20 cm. to
31
UK
57