Corghi HD 700 Manual De Usuario página 52

9) Turn the wheel anticlockwise keeping the
lever pressed down (A, Fig. 22) until the bead
exits completely.
10) Position the tool holder arm in the non-
working position and move it to the inner side
of the wheel.
11) Move the mobile control unit to work-
ing position D.
12) Turn the hook tool 180°, insert it between
the rim and bead (see fig. 23) and move it until
the bead is near the front rim edge (it is recom-
mended to perform this operation turning the
wheel at the same time).
13) Move the rim about 4-5 cm away from the
tool making sure the bead does not detach
from the tool.
14) Move the mobile control unit to work-
ing position B.
15) Move the hook tool so that its red reference
dot is positioned 3 cm. inside the rim.
16) Insert the lever (A, Fig. 22) between the rim
52
and the bead to the right of the tool.
17) Keeping the lever pressed down, lower the
wheel to bring the rim edge about 5 cm from the
hook tool, then turn the wheel anticlockwise until
the tyre comes completely off the rim.
CAUTION
When the beads come off the rim, the
tyre will fall.
Make sure that no one is accidentally
located in the work area.
MOUNTING
Tubeless tyres can be mounted using the
bead breaker disc or the hook tool.
If the wheel is not difficult to mount, use the
bead breaker disc; otherwise, the hook tool
must be used.
MOUNTING WITH THE DISC
Follow these steps:
1) If the rim has been removed from the turn-
table, reclamp it as described in the "WHEEL
CLAMPING" paragraph.
2) Lubricate the tyre beads and rim using the
recommended soapy solution.
3) Tighten the rim gripper on the outer side of
the rim at the highest point (see fig. 24).
23
CAUTION
Make sure that the gripper is well at-
tached to the rim.
- E - Operator's manual HD 700
nglIsh