Corghi HD 700 Manual De Usuario página 53

4) Move the mobile control unit to work-
ing position B.
5) Position the tyre on the platform and lower
the turntable (making sure to keep the gripper
in the highest point) to hook the first bead to
the gripper.
6) Lift the rim with the tyre hooked to it and turn
it anticlockwise about 15-20 cm. The tyre will be
positioned tilted across the rim.
7) Move the mobile control unit to work-
ing position C.
8) Position the bead breaker disc against the
second bead of the tyre and turn the turnta-
ble until the gripper is at the lowest point (6
- E - Operator's manual HD 700
nglIsh
o'clock).
9) Move the bead breaker disc away from the
wheel.
10) Remove the gripper and refit it in the same
position (6 o'clock) outside the second bead
(see fig. 25).
11) Turn the turntable clockwise 90° until the
gripper is in the 9 o'clock position.
12) Move the bead breaker disc forward until
it is 1-2 cm inside the rim edge, making sure it
remains approx. 5 mm from the profile.
Start the clockwise rotation making sure that
24
after a 90° turn, the second bead starts to slip
into the rim well.
13) When mounting is complete, move the tool
away from the wheel, tip it into a non-working
position and remove the gripper.
14) Position the platform under the wheel,
lower the turntable until the wheel rests on
the platform.
15) Move the mobile control unit to work-
ing position B.
16) Completely close the turntable clamps,
making sure that the wheel is supported to
prevent it from falling.
CAUTION
This operation can be extremely dan-
gerous!
Perform it manually if you are absolutely
certain you can maintain the wheel equi-
librium only.
For heavy, large sized wheels you MUST
use a suitable lifting device.
17) Move the platform to move the wheel away
from the turntable.
18) Remove the wheel.
N.B.: If the tyre permits it, the opera-
tion described above can be speeded
up by mounting both beads at the same
25
time:
UK
53