Nubax Trio Manual De Instrucciones página 11

103020 NubaxGuide Trio v3.3 English_NubaxGuide English Master.qxd 27/03/13 9:37 AM Page 10
ASSEMBLY INSTRUCTIONS
Step 8
bjective
Attach the waist belt to the main frame.
Place the waist belt across the top of
the rear end of the main frame. Take a
short bolt and place it through the single
eyelet on one end of the belt and then
placing the belt and eyelet over a hole
on one side of the frame, push the bolt
through the hole from the top side.
Secure the bolt from underneath with a
plastic handled nut. Repeat this process
for the opposite size, selecting an eyelet
close to the foam padding on the waist
belt. (When you first go to use your
Nubax Trio you should start with a
page
short belt setting and increase the length
10
of the belt gradually as you become
familiar and confident with its use.)
Step 9
Congratulations and welcome to your Nubax Trio.
Assembly should now be complete. However, before you commence using the
Nubax Trio for the first time, double check your assembly to ensure that all
fastenings are tight and secure. Then read the manual and watch the DVD so that
you are familiar with its correct use. Remember to check your Nubax Trio from time
to time for any fastenings that may have come loose and for signs of wear and tear
of the belt or fraying around the eyelets.