Descargar Imprimir esta página

Parkside PMRA 20-Li B2 Traduccion Del Manual De Instrucciones Originale página 56

Traducción del manual de instrucciones original

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 140
GB MT
The lawn mower is now in standby
mode.
If you have entered the wrong PIN:
Wait about 3 seconds or press the
OK button (7) to be able to enter the PIN
again.
If you enter an incorrect PIN three times in
a row, the screen is locked for 15 seconds.
For each additional incorrect PIN, the
blocking time is doubled.
Switching off the lawn mower
1. Press and hold the START button (3) for
about 3 seconds.
The lawn mower stops if:
-
the STOP button (9) is pressed
-
the cover (1) is raised
-
it loses the boundary wire signal and
does not find it again within 5 minutes
-
it crosses the boundary wire when
mowing.
-
it gets stuck between obstacles and
needs more than 10 seconds to find a
way out.
-
it is raised
Mowing
There are two different modes: manual
mowing and scheduled mowing.
In both modes, the mower automati-
cally runs the boundary wire once
after every seventh activated day and
mows this area.
Depending on the nature of the
grass (height, thickness), the robotic
lawn mower adjusts its mowing speed to
ensure a good result.
56
Manual mowing
Prerequisites for starting "manual
mowing" mode:
-
The mower must be in standby mode
to start manual mowing (see sec-
tion "Switching on and off", section
"Switching on the mower").
Starting from the charging station re-
-
quires a battery capacity of more than
70%. Otherwise, the mower automati-
cally switches to charge mode until the
capacity is more than 90%, then it au-
tomatically leaves the charging station.
Starting outside the charging station
-
and inside the boundary wire requires
a battery capacity of more than 30%.
If the battery capacity is less than or
equal to 30%, the mower automatically
returns to the charging station.
1. Open the cover (1).
2. Unlock the display (10) with the 4-digit
PIN.
3. Press the OK button (7).
4. Press the START button (3) for 1 second
to start manual mowing.
In this mode, the device works as long
as you have set the operating time (see
section "Setting the operating times") or
until max. 24 hrs. At 24 hrs, the device
automatically returns to the charging sta-
tion and starts the following day according
to schedule if a start time has been pro-
grammed. Otherwise, the device remains
in the charging station.
If the STOP button (9) is pressed in
this mode, the message "Emergency
stop" appears in the display followed by
the message "Continue work?". Confirm
with the OK button (7) to start manual
mowing again or end manual mowing by
pressing the Back button (5).

Publicidad

loading