Publicidad
Idiomas disponibles
Idiomas disponibles
GB MT
Low battery voltage
Low battery voltage,
charge to start
Low battery, return to
charging station
Unexpected charging
error
Charging current too
low
No signal from
boundary line
No signal, please set
up the boundary line
first
Loop signal lost
Mower locked!
Waiting time...
Wrong PIN, please try
again.
Please place within
the boundary and try
again
Mower outside
Please reboot to start
the firmware update
Work interrupted,
please try again
Rain sensor activated
Mower in the station
Mower is not in the
station
Press the start button
to start
60
The charge level of the battery does not meet the minimum
requirements at the start of work:
70 % for automatic mowing
30 % for fixed point mowing (spot mode)
Place the lawn mower in the charging station
or to wait for the charging process to finish
or lawn mower returns to the charging station independently
Check cause on site, if necessary check correct contact
between unit and charging station. Restart the charging pro-
cess by restarting the device and placing it in the charging
station again
Check power supply
Check correct installation of the boundary line and correct if
necessary,
Place the lawn mower inside the boundary and restart it
Wait until the currently running process is completed
Enter the PIN again
Place the lawn mower inside the boundary and restart it
Restart lawn mower
Rain sensor is activated
Mower in the station
Mower is not in the station, if necessary place the mower in
the station
Press the START button (3)
Publicidad
