Publicidad
Idiomas disponibles
Idiomas disponibles
GB MT
Motor error
EM sensor not
connected
Hall sensor failure
Hardware error
Charge abnormal
Discharge abnormal
Battery discharge error
Inertial measurement
unit (IMU) error
Motor error
Motor switched off
Motor Hall sensor error
Motor overcurrent
Motor blocked
Motor standstill right
Rain sensor failure
Loop sensor failure
Setting the date and time
1. If necessary, open the cover (1).
2. Unlock the display (10) with the 4-digit
PIN.
3. Press the OK button (7) to enter the
main menu.
4. Use the arrow buttons (6) to select "Set-
tings".
5. Confirm the selection with the OK but-
ton (7).
6. Use the arrow buttons (6) to select
"Date and time".
7. Confirm the selection with the OK but-
ton (7).
8. Change the date and time with the
arrow buttons (6). The individual po-
sitions can be navigated with the OK
button (7) (skip the right).
The correct date and time setting is
required to ensure the correct func-
tion of the operating time settings.
62
Contact manufacturer (see "Service Centre")
Restoring factory settings
The lawn mower can be reset to factory
settings here.
1. If necessary, open the cover (1).
2. Unlock the display (10) with the 4-digit
PIN.
3. Press the OK button (7) to enter the
main menu.
4. Use the arrow buttons (6) to select "Set-
tings".
5. Confirm the selection with the OK but-
ton (7).
6. Use the arrow buttons (6) to select "Fac-
tory settings".
7. Confirm the selection with the OK but-
ton (7).
The lawn mower switches off
and resets itself to the factory
setting.
Publicidad
